If there are no external signs of damage to any parts, attempt the procedure below before replacing a cylinder head, cylinder head bolts or cylinder head gasket. Whenever re-torqueing the cylinder head bolt(s), be sure to follow the torque sequence as outlined below. The latest bulletin applies to vehicles equipped with a 2.4L engine built between Feb. The previous bulletin should be removed from your files. The information supersedes the previous technical bulletin, dated March 25, 2005. In 2008, Chrysler revised its 2.4L cylinder head bolt re-torque procedure.
#Timing belt tensioner wrench install#
Install the air cleaner housing, upper cover and clean air tube.
Install the crankshaft vibration dampener.ġ3. Install the air conditioning/generator belt tensioner and pulley.ġ1. Tool 9131 - Timing Belt Tensioner Tool (Instructions) 000.721.913.1A E-mail this product to a friend. The Kricket tool really is only good for cars without the spring tensioner. Im at about 2000 miles and its still running strong. I recently did the retension for 1500 miles, same procedure. Install the timing belt front covers and bolts.ġ0. I used the spring tensioner to set initial tension and checked, double checked and triple checked using the Kricket tool. If the spring tang is not within the tolerance window, repeat steps 5 through 7.ĩ. If so, the installation process is complete and nothing further is required. Check to see if the spring tang is within the tolerance window. Verify that the crankshaft and the crankshaft timing marks are in proper position.Ĩ. Once the timing belt has been installed and the tensioner adjusted, rotate the crankshaft clockwise two complete revolutions manually for seating the belt, until the crankshaft is repositioned at the TDC position.
#Timing belt tensioner wrench verification#
Do not rotate crankshaft counterclockwise as this will make verification of proper tensioner setting impossible.ħ. Belt Release Tool Adapters: Sockets 15 mm, 16 mm, 18 mm. Variable Valve Timing (VVT) Maintaining Tires Replacing a Belt Replacing Brake Pads Replacing a Headlamp. Get deals on automotive parts, truck parts and more. If TDC is missed, rotate a further two revolutions until TDC is achieved. Buy NAPA Belt Tool - BK 7769078 online from NAPA Auto Parts Stores. Note: Repositioning the crankshaft to the TDC position must be done only during the clockwise rotation movement. Remove the Allen wrench and torque wrench.
The setting notch and spring tang should remain aligned after the lock nut is torqued.Ħ. Using the Allen wrench to prevent the top plate from moving, torque the tensioner lock nut to 22 ft.-lbs. Watching the movement of the setting notch, continue rotating the top plate counterclockwise until the setting notch is aligned with the spring tang. The tensioner pulley will move against the belt and the tensioner setting notch will eventually start to move clockwise. Insert a 6 mm Allen wrench into the hexagon opening located on the top plate of the belt tensioner pulley.
Move the exhaust camshaft sprocket counterclockwise to align the marks and to take up belt slack.ĥ. Starting at the crankshaft, go around the water pump sprocket, idler pulley and camshaft sprockets and then around the tensioner.Ĥ. Set the crankshaft timing marks so that the exhaust camshaft sprocket is half of a notch below the intake camshaft sprocket.ģ. Set the crankshaft sprocket to TDC by aligning the sprocket with the arrow on the oil pump housing.Ģ. Window.dataLayer = window.The naturally aspirated 2.4L 4-cylinder PowerTech engine provided 150 hp (110 kW) and 165 lb.-ft. Image is representative and may not depict the actual product.
0 kommentar(er)
